Polaris 65 Turbo Turtle Swimming Pool Pressure Cleaner Manual

Polaris-65-Turbo-Turtle-Swimming-Pool-Pressure-Cleaner-Manual-prduct-img

CAUTION:

USE OF POLARIS 65/165/Turtle IN A VINYL LINER POOL
Certain vinyl liner patterns are particularly susceptible to rapid surface wear or pattern removal caused by objects coming into contact with the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and automatic pool cleaners. Some vinyl liner patterns can be seriously scratched or abraded simply by rubbing the surface with a pool brush. The ink from the pattern can also rub off during the installation process or when it comes into contact with objects in the pool. Zodiac Pool Systems LLC and its affiliates and subsidiaries are not responsible for, and the Limited Warranty does not cover, pattern removal, abrasion, or markings on vinyl liners.

This manual contains essential installation and startup instructions. Read the online manual and all safety warnings before commencing installation. Visit www.zodiac.com for additional operating and troubleshooting instructions.

Polaris 65/165/Turbo Turtle Complete Cleaner

Polaris-65-Turbo-Turtle-Swimming-Pool-Pressure-Cleaner-Manual-fig-1

a1. Surface Module
a2. Turtle Top
b. Wheel Cage
c. Sweep Hose
d. Float Hose Extension with Connector (165 only)
e. Float
f. Hose Connector, Male
g. Hose Connector, Female
h. Jet Sweep Assembly
i. All-Purpose Bag
j. Float Hose
K. Quick Disconnect with pressure relief valve (k1)
l. Universal Wall Fitting (UWF®/QD)
m. Eyeball Regulators (2) (165 only)
n. Filter Screen (UWF/QD)

Install to dedicated pool cleaner return line

Polaris-65-Turbo-Turtle-Swimming-Pool-Pressure-Cleaner-Manual-fig-2

a. Turn on the filtration pump and flush out the plumbing line. Turn the pump off.
b. Screw the Eyeball Regulators (m), if necessary, and UWF (l) into the return line opening.
c. Turn the Quick Disconnect (k) clockwise into the UWF and pull away to secure.

Adjust sweep hose to fit pool length

Adjust sweep hose to fit pool length

a. Measure the deepest part of the pool. Add 2′ (60 cm) to this measurement to determine the correct length of the sweep hose.
b. If the sweep hose is longer than the measured amount, then cut the excess hose.

Adjust the float hose to fit the pool length

a. Measure to farthest part of the pool. The end of the hose should be 4 feet (1.2 cm) shorter than this point.
b. Assemble as shown.

b. Assemble as shown.

Fine Tuning

Pressure Relief Valve (k1)
Unscrew to decrease water flow to cleaner

Unscrew to decrease water flow to cleaner

Clean

Polaris-65-Turbo-Turtle-Swimming-Pool-Pressure-Cleaner-Manual-fig-6

Polaris-65-Turbo-Turtle-Swimming-Pool-Pressure-Cleaner-Manual-fig-7

Zodiac Pool Systems LLC

2882 Whiptail Loop # 100, Carlsbad, CA 92010
1.800.822.7933 | PolarisPool.com

ZPCE

ZA de la Balme – BP 42
31450 BELBERAUD
FRANCE | zodiac.com

©2021 Zodiac Pool Systems LLC
All rights reserved. Zodiac® is a registered trademark of Zodiac International, S.A.S.U. used under license. All other trademarks referenced herein are the property of their respective owners.
H0410200 Rev D